Running a Web Vuser Script Using QuickTest
Web Vuser Scripts · Running Web Vuser Scripts
Creating Vuser Scripts
Chapter 21, page 351
Running a Web Vuser Script Using QuickTest
In order to perform load testing with a Web Vuser script, you need to incorporate
the script into a LoadRunner scenario. Before integrating the script into a scenario,
you should check its functionality by running the script in stand-alone mode.
stand-alone mode
Running a script in stand-alone mode means running the
script without using a LoadRunner Controller. This is done
to establish how the script will execute when run as part of
a scenario. You use QuickTest to run a script in stand-alone
mode.
If the stand-alone execution is successful, then incorporate the script into a
scenario. For more information on LoadRunner scenarios, refer to your
LoadRunner Controller User's Guide
.
When you run a Web Vuser script using QuickTest, QuickTest navigates through
your web site, performing the user processes that you recorded.
